SANISPLIT BS3
Sanitary Pump Station
Sanisplit
Description
This model is for use with a single P or S pan toilet. In addition, further units eg: basins, sinks, washing machines can gravity feed into the rear of the pump through a 40mm (dwv) entry at 160mm (centre) from bottom of pump. Further entry is offered by way of a second 40mm entry at 95mm (centre) from bottom of pump for bath and/or shower. Choice of internal venting, or if remotely installed venting to atmosphere. Discharge at rear of pump through 32mm class D pressure pipe at 215mm (centre) from bottom of pump.
For remote installations, i.e. when the pump is not connected directly to the toilet pan, the maximum permissible distance from the pan to the pump must not exceed 150mm. Failure to comply with this requirement will invalidate the warranty.
IT IS NOT RECOMMENDED TO DISCHARGE THE FOLLOWING INTO A SANI-SPLIT PUMP –
- sanitary pads and tampons
- excessive quantities of toilet paper
- sani wipes
- paper towels
- coffee grinds
- commercial kitchen fats
- for commercial installations, install a sign on the toilet cistern to point out what must not be flushed
- in commercial kitchens, the installation of a grease trap is recommended
- If any of the above do enter the pump, they may cause a blockage. In the event that this occurs however, the unique split system design of the pump readily facilitates un-blocking, without having to call in a plumber, or to have to disconnect the pipe work.
- 3 year warranty
